SFBC+M- Controller for Boilers of Mixed Use Wood & Biomass

The main feature of SFBC + M is that during its operation can only use wood or biomass or start burning wood when it is exhausted to continue with the burning of biomass or commisioning an auxiliary fuel boiler.

Thus in cases where the supply of wood is not possible, heating is not discontinued.

Maximize Wood & Biomass Energy Yield

Modern biomass boilers require specialized solutions and accurate control over their operation to perform to their full capability.

SFBC+M perfectly complements any biomass boiler aimed at users' requirements. It incorporates the most sophisticated techniques at wood combustion to maximize heat gain yet eliminate misoperation.

Its careful design allows boilers to serve residential and small blocks of flat buildings.

Wood & Biomass Combustion Demands

The burning of wood & biomass is particularly demanding when a challenge is to ensure the quality of heating.

The SFBC+M addresses all the problems most effectively:

• Overheating

The speed of the blower is adjusted proportionally and not in steps; thus, any overheating symptom is avoided.

• Corrosion

The temperature is monitored continuously and maintained at a point which prevents corrosion

• Burning chamber contamination 

The adjustable function between carefully selected temperature limits minimizes the deposit accumulation.

• Undesirable burnout

The operation of the SFBC+Μ is based on 2 analog regions corresponding to normal and reduced capacity. Thus, the reduced demand for heat leads to adequate combustion levels and no fire extinction.

• Fuel waste

The SFBC+Μ recognizes by considering specific criteria when the heating requirement has been eliminated and goes to low power mode. Therefore it saves fuel when needed.